Файлообмен > для_админа
работы
mentat-vvo:
Cut off VEMS, running DAEWOO ESPERO 2.0L C20LE engine (IEFI-6 PnP).
Features:
1) Bluetooth adapter on-board for comms.
2) An additional relay makes power work properly (IGN signal toggles relay ON, which powers board).
3) IGN signal is also wired directly to ADC to make MСU sense injectors voltage more accurately.
4) I259_0 signal (tied up to a "relay" in the distro) switches between factory safe mode (ECU is dead, angle=10 BTDC) and ECU-controlled mode. It is enabled (set to logic one, +5v) when RPM > 50.
The config is driveable, but IAC settings are not tuned well. The "TDC after a trigger" var is set to ~35 to match the factory 10 degs BTDC at 10 degs locked at vems. Probably, coil pickup signal should be inverted.
mentat-vvo:
Переходник к плате VEMS для корпуса от 1G-FE AT. Переходник универсален, выводятся почти все сигналы из/в VEMS. Подойдет к любым моторам до 6ц фазированного впрыска, зажигание до 6-каналов, АТ/MT, VVTi на впуске, буст-соленоид, ШЛЗ, вот это все.
Навигация
Go to full version